-
Ice Breaker
Ice Breaker is another funny Puzzle game by Nitrome. "In this game, you have to save the frozen vikings by clicking and dragging with the mouse to slice through the ice to get them back to their longboat." Good luck and have fun! [Subbed by Tosca]
Play This Game
155 comments:
-
29 - release "miss piggy" to get ball in, kill her, then slice iceberg from bottom of left pin close to foot of vicking,the vertical cut as close as possible vicking on his right side then another cut next to previous this will release him, as he swings to left you will have to release him from pin and he will land on the boat, the top vicking you will have to make him swing from BOTTOM pin in a thin slice and relese him on 1st swing - timing , SORRY Patricia didn se you question on time
-
ok.slowly then;-)free the spinning wheel that it can spinnthen free the long thing that looks like a chocloate from the side from the right nail.then free the stone-thing so it fall over the ice chocolate.then freen the icechocolate-it is falling down while spinning the wheel...
then cut the wiking off...timing there
-
Okay Notty,
I shaved the side of the block of ice furthest away from boat. The block will rotate to the right... at it's highest point of rotation, shave the left side of the block (in both cases, shave as close to the pivot point). When the rotation of the remaining ice hits the highest point to the left, free your viking!
-
32 is tricky... it takes me a few tries...
i think first i cut off the uppest vikinger, he goes directly in the boat or in the hole from the middle icesculpture (cut it maybe 2 times..)
then i cut the first pin off from the upper sculpture and finally the other first from the other sculpture..oh and dont forget to cut off the frozen one...
sorry..im from germany cant explain very well...
-
Finally got 32! Cut top viking off, he slides right into boat. Cut frozen viking, he slide right in too. Third viking I chopped the upper ice formation so that a large block landed between him and the ice on his left. this made him slide over to the right and with a few more well placed slices he slid right into the boat.
-
17.. cut at first the right rope from the women on bottom left. then vut the right rope from the woman over the big wodden block and the left. then, when the 2 womans are in place under the wodden block cut it down. kill the 3 womans under the other block.
then cut the right rope from the uppest woman she will push the monster away. finally let the viking toll down..(=
-
Patricia,
Cut the ice holding the viking (cut it flat). Then quickly move up and to the right where the steel beam is connected to the ice block. Cut the ice block between the two pins, but make sure that when the whole thing falls that the ice block and rope assembly falls in front of the steel beam. With this accomplished, simply go up and cut the ice formation above at the top and it will swing down and help push the viking into the boat.
-
Hey Rambler10,
Shave the bottom of the ice off just below the pin. After that, make two quick cuts on both sides of the pin that will allow the vikings to slide to the middle where (ideally) they will come to rest on the block of ice that is sitting on the boat. (this is the first one you shaved off) Then simply make enough cuts so that the fella with the hammer can free them. Hope this helps!
-
@ Rambler10 (38) the 4 vickings are balanced on the ice platform, make an horizontal cut so the platform will end up with half of its thikness (as straight as possible so the top half stays balanced),the bottom half will fall on top of the boat and form a "bridge" as its bigger than the boat, then cut it in half - vertical cut - u end up with 2 "ramps" inside the boat.
Got to the top one ( where the vickings are hopefully still balanced) and cut it in half - verical cut- close to the pin...both halves + the vickings will fall on the "ramps" and into the boat, then chop the lot in bits..u will get it after a few attempts...
-
40
Slice ice under viking in a horizontal manner. Quickly move up and cut the ice block holding the steel beam. (this must be cut so that the ice block/rope combo swings in front of the beam as it falls to the left) Then simply cut the top of the notched ice piece above (right below the top pin) and this will slam into the steal beam, shoving the viking to the left and into the boat.
-
I just played 40 again.
1. Quickly move up and cut ice/rope combo just under top pin (use momentum of steel beam to insure that when it falls, it (ice/rope combo) falls in front of steel beam.
2. Take your time now.
3. Slice just under viking to free him from ice block he is on top of.
4. Cut top ice piece just under top pin.
5. You're out!
-
37: cut off all the ice between the two left dots.this will make falling of left viking into boat easier
now cut ice around middle dot in such a way that thers a huge piece of ice revolving on the right side and the middle one is not slowing it down
cut the rope at the correct moment when the right viking will fall on right ice such that it goes on the left side of ice rather than the right which took him into water
it was the way i could do it and took me quite some tries.hope it helps:)
-
Ah, i just managed it 39 :D
The order should be:
-cut the rope
-slice the ise from the top on the comb, it falls down
-slice the comb from the bottom, it slides but stays behind the wheel
-slice the ice where the viking is stuck
The comb makes wheel twirling, then try to slice the viking side. It flys to boat!
:P
-
Eugenia, 29 is simple actually
Cut the ice so the fat lady slides with the viking who's on the ice, the fall to the boat
Then slice the ice from the bottom which is supposed to fall in to the water. Quite near the two vikings
Left viking - cut ice from his right, but very near him. He starts swinging, so be ready to cut on the move
Same thing with the last one. Cut so that it starts also swinging and it flys to the boat :)
-
25 lukozade :)
Slice a little the tip near the boat, so the ice would be a bit shorter, but with an angle, towards the boat..
Then slice from the left of the viking, but so that he would be attached to the thingy from the bottom
It falls to the right (maybe u hav to help with it too slicing the ice away)
And cut the viking, he slides to the boat :))
-
39
- cut a line from right side of the right viking, pull it straight down to the right side of the lower right nail.
Make sure your boss destoy all pices in the boat.
- make a horisontal line from upper left(just where the ice start to go down on left side). Draw the line right and make it go a bit down to the right end. This will make a platform that the 2 vikings on the top will slide when u do next part.
Next step you are gone have 3 moving ice parts 1:the one the 2 vikings are standing on. 2: the lower right nail. 3: the upper nail, with the last viking on(hes gone stay inside the hook.
And here comes the real hard part...
- make a cut from right side of upper nail(close as u can get)and up. !!!DO NOT CUT THE ONE THE 2 VIKINGS ARE STANDING ON!!!
This will trigger the 3 ice blocs i mention, now hurry and cut the lower right nail ice in half. This will prevent the 2 vikings to jump overboard on other side.
The last viking will be inside the hook. Cut the hook when he is moving to the right side, he will then be casted inside the boat :)
-
level 40 can be passed a lot easier! just make shure the forzen viking can be kicked away. DO NOT CUT THE ROBE! you dont need it at all! just cut away the spikes on the "ice-hammer", so it can hit your viking. then try to make the hammer as thin as possible, so it wont kick the viking to far! then just let it kick him into the boat.... easy as pie.
Casualgamer
If you want to more escaping fun, try Trapped - The Abduction game.
first.